roaddogtx
12-29-2003, 11:39 PM
i need some advice in scroll sawing if anyone can help me im looking in to makeing some custom computer cases makeing desgins in the side panels its a great idea i already have people that would buy them soo on that note ive gotten a few junky cpu cases and and a few desgins but now i need a tool to cut the metal . its about a 1/16 thick and ive tryed a Dremel hand grinder well you tell me dident work :eek: but then i was thinking about my friend that dose wood work with a scroll saw ive looked around at some blades but none of them say how thick the metal can be . so is this a good idea or any of you fine folks out there have a better or faster way to cut this stuff . i have fine points that i would like to make... so attention to detail will be high thank you very much
Dale
Dale